G 20 Van V8-379 6.2L DSL VIN C FI (1992)
Note:
Chemical stripping is not recommended because of negative impact to moldings, non-metal components, ELPO and environmental concerns.
4.
Blow off with air to remove all dirt and sanding residue from cracks and vehicle surface.
5.
Clean sanded surface with an appropriate wax and grease remover.
6.
Tack wipe entire area to be primed.
7.
Spray entire prepared area with a coat of anti-corrosion primer to ensure maximum adhesion and corrosion resistance. Be sure to cover any bare
metal surfaces exposed during the sanding operations. Follow manufacturer's instructions and recommended dry times.
Typical materials for this application would be: DuPont 615S/616S, BASE DE17/PR8O/DA18, PPG DP4O/DP401, or equivalent.
V.O.C. materials would be: DuPont 615S/616S, BASF DE15/PA16/PRB0, PPG DCP21/DCX211 or equivalent.
8.
Apply two to three medium wet coats of primer surfacer to the primed surface of the vehicle, following the manufacturer's instructions for
application and film build requirements.
Important
Failure to apply primer surfacer will likely result in future delamination.
Typical materials for this application would be: DuPont 1120S/1130S/1125S, BASF DP20/PR80/PH36, PPG K36/DT870/K201, or equivalent.
V.O.C. materials would be: DuPont 210S, BASF HP400, PPG DCP21/DCX211, or equivalent.
9.
After allowing adequate drying time, wet sand with 400 grit (or finer) or dry sand with 320 grit (or finer) sandpaper.
10.
Repeat steps 4 through 6.
11.
Apply a medium coat of corrosion resistant primer sealer (tintable base) to the entire surface to be refinished. This will provide maximum
adhesion, uniform color coating and corrosion protection to areas "sanded through" during wet sanding. Follow manufacturer's instructions and
recommended dry times.
Typical materials for this application would be: DuPont 2610S/2605S, BASF DP21/DH6O/PR80, PPG DP40/DP402 or equivalent.
V.O.C. materials for this application would be: DuPont 21255, PPG DPW1834 or equivalent.
12.
Apply two to three medium wet coats of color (or until primer color is hidden). Follow manufacturer's instructions and recommended dry times.
13.
If vehicle has basecoat/clearcoat paint, apply clearcoat. Follow manufacturer's instructions and recommended dry times.
14.
After sufficient air or force dry time, unmask the vehicle.
15.
Finesse/polish as required.
16. Reinstall all previously removed items.
17. Wash and prepare the vehicle for delivery.
HARDWARE ITEMS REMOVAL LIST
Note:
Some technicians may apply a small cord (wire, plastic tube, etc.) behind or underneath moldings that remain on the vehicle to improve sanding and
painting. If the vehicle paint system is baked with cord in place, damage to some moldings may occur. If this technique is used, DO NOT BAKE
PAINT air dry only
Note:
Only items marked with an asterisk are "add" conditions to the Major Operation being performed. Removal time for all other items listed is included
in the refinish time.
LIGHT DUTY TRUCKS
C/K TRUCKS
Grille
Front bumper filler
