G 20 Van V8-379 6.2L DSL VIN C FI (1992)
4. The other end of the hose into a suitable container
-
Disconnect the fuel injection pump shutdown solenoid wire
-
Crank the engine for 10 to 15 seconds and then wait one minute for the starter motor to cool. Repeat until clear fuel is observed coming
from the air bleed.
-
Close the air bleed
5. Injection pump shutdown solenoid wire
6. Fuel filler cap
-
Start the engine and allow it to idle for five minutes
-
Check the fuel filter for leaks
NOTE:
All component parts of the fuel filter assembly are serviceable. These components include the filter adapter, fuel heater, and the water sensor.
Always replace any damaged or worn O-rings, gaskets, or seals. After replacing components, bleed air from the filter to save cranking time. Start
the engine and check for leaks after replacing components.