G 20 Van V8-5.7L VIN R (1996)
Engine Control Module: Service and Repair
EEPROM Programming
CAUTION: The ignition should always be "off" when installing or removing the Vehicle Control Module (VCM) connectors.
1. Set-up:
^
Battery is charged.
^
Ignition is "ON."
^
Battery/cig. lighter Connection secure.
^
Data Link Connector (DLC).
2. Refer to up-to-date Techline terminal/equipment user's instructions.
3. If Vehicle Control Module (VCM) fails to program, do the following:
^
Check all VCM connections.
^
check Techline terminal/equipment for latest software version.
^
Try again to program the VCM. If it fails again, replace the VCM. Refer to VCM replacement. See: Control Module Replacement
4. Perform the Idle Air Control (IAC) valve reset procedure with the scan tool. use misc. test.
5. For a functional check perform one of the steps:
^
Use the Techline terminal and equipment in order to perform the On-Board Diagnostic (OBD) System Check
^
Refer to Powertrain OBD System Check. See: Powertrain Management/Computers and Control Systems/Testing and Inspection