G 2500 3/4 Ton Van V8-305 5.0L VIN M SFI (1997)
2. The retaining ring (E-Clips) securing the cooler line to the quick connect.
NOTE Ensure the following procedures are performed when removing the retaining ring and cooler line from the quick connect fitting.
A. Pull the plastic cap back from the quick connect fitting and down along the cooler line about two inches.
B. Using a bent-tip screwdriver, pull on one of the open ends of the retaining ring to rotate the retaining ring around the quick connect fitting until
the retaining ring is out of position and can be completely removed.
C. Remove the retaining ring from the quick connect fitting.
D. Discard the retaining ring.
E. Pull the cooler line straight out from the quick connect fitting.
F. Repeat Step 2 to remove the remaining cooler lines from the remaining quick connect fittings.
INSTALLATION
1. "NEW" retaining ring (E-clip) into the quick connect firing.
NOTE
^
Do not reuse any of the existing retaining rings removed from the existing quick connect fittings. All retaining rings being installed must be
"NEW."
^
Do not install the new retaining ring onto the fitting by pushing the retaining ring down over the fitting.
