G 2500 3/4 Ton Van V8-305 5.0L VIN M SFI (1997)
Tool For Removing Center Support Bearing
Tool For Removing Center Support Bearing (Side View)
Tool For Removing Center Support Bearing (Installation View)
REMOVE OR DISCONNECT
NOTICE: Sell bearings that are removed from the armature must be replaced with new bearings. The removal procedure causes Internal damage to the
bearings.
1. Center support bearing (32) from the driveshaft (31) using a locally fabricated tool as shown. With the driveshaft in a suitable support fixture,
place the tool bolt ends through the access holes in the wide end of the driveshaft. Squarely press the bearing off of the surface on the center shaft.
