G 2500 3/4 Ton Van V8-305 5.0L VIN M SFI (1997)
Pinion Stop Support Block
C. Pick the assembly up and support it under the pinion stop (36). A metal block, with a U-shaped cutout that will slide over the shaft between the
pinion gear and stop, can be clamped in a vise to provide support.
D. Make sure the stop rings (35) in the driveshaft groove are fully seated in the pinion stop recess and stake the upper edge of the pinion stop (36)
over the stop ring (35) at four places, equally spaced. Do not allow the staked metal to contact the driveshaft (31).
Gear Reduction and Drive Group
Gear Reduction And Drive Group
Important
^
If the drive end bushing and plug are being replaced, install them in the drive housing.
^
Lubricate the drive end housing bushing, shift lever, and driveshaft as described in "Lubrication".
Gear Reduction And Drive Group
