Testing and Inspection for the Assembly of SD-255 Starter Motor (Page 9086)
Electrical Group
Aligning Timing Marks
Electrical Group
Support the gear reduction and drive group with the pinion gear end down and proceed as follows:
Important: If the armature bearings are being replaced, install them on the armature.
INSTALL OR CONNECT
1. Solenoid assembly.
A. Pivot the plunger of the solenoid assembly into engagement with the shift lever in the gear reduction and drive group.
B. Position the solenoid assembly mounting flange and install the solenoid mounting screws.
Tighten
^
Solenoid screws to 2.8 N.m (25 lb in).
2. Frame seal.
3. Armature assembly with bearings into the gear reduction and drive group.
^
Make sure the gear teeth are aligned, then seat the bearing on the armature shaft fully into the housing recess.
