G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1997)
Electronic Brake Control Module: Service and Repair
Tube Adapters
REMOVE OR DISCONNECT
1. Raise vehicle and properly support.
2. Three Electro-Hydraulic Control Unit (EHCU) shield bolts.
3. EHCU shield.
4. Appropriate brake line from the tube adapter.
5. Tube adapter.
INSTALL OR CONNECT
1. New tube adapter.
^
Tighten tube adapter to 31 Nm (23 ft. lbs.).
2. Brake line.
^
Tighten brake line to 30 Nm (22 ft. lbs.).
3. EHCU shield.
4. Three EHCU shield bolts.
^
Tighten three bolts to 12 Nm (8 ft. lbs.).
5. Bleed the system. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Service and Repair
NOTE: If more than one tube adapter is to be removed at one time, the Brake Pressure Modulator Valve (BPMV) should be stamped with a
number (1, 2 or 3) to correspond with the number of grooves cut into the tube adapters. This will aid in proper reassembly.