G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1997)
Remove or Disconnect
-
Power steering pump from vehicle. Refer to "Power Steering Pump Replacement."
Disassemble
1. Pump reservoir. Refer to "Pump Reservoir Replacement."
2. Retaining ring (25).
3. End plate (23) and spring (22).
NOTICE: Examine exposed portion of pump drive shaft. If it is corroded, clean with crocus cloth before removing. This will prevent damage to
the shaft bushing which might require replacement of the entire housing.
4. Pressure plate (21) by using a rubber mallet to tap lightly on the drive staff (12).
5. Pump ring (20).
6. Pump vanes (18).
7. Shaft, rotor and thrust plate assembly.
8. Shaft retaining ring (17).
9. Pump rotor (16).
10. Thrust plate (15).
11. Drive shaft (12).
12. Dowel pins (13).
13. O-ring seals (3 and 5).
Important: Use new seals and drive shaft retaining ring when assembling pump.