G 30 1 Ton Van V8-379 6.2L DSL VIN J FI (1984)
FIGURE 3 - Injection Pump
2.
Disconnect the fuel injection pump shut off solenoid wire (pink wire) (Figure 3).
3.
With the air bleed open, crank the engine 10 to 15 seconds. Wait 1 minute for the starter to cool. Repeat until clear fuel is observed at the air
bleed.
4.
Close air bleed and reconnect injection pump solenoid wire.
5.
Repeat cranking 10 to 15 seconds until engine starts.
Fuel Filter, Water Drain
To drain water:
1.
Remove the vehicle fuel tank cap.