G 30 Van V8-454 7.4L VIN J SFI (1996)
17.
Install coated bolts in revised tightening sequence (see figure 1) to torque of 8 Nm (6 lb. ft.).
18.
Retorque all bolts in sequence to 14 Nm (10 lb. ft.).
19.
Connect all electrical connectors to components attached to upper intake manifold.
20.
Install ignition coil to intake manifold.
21.
Install right rear and front wire harness brackets.
22.
Install left rear and front wire harness brackets.
23.
Install EGR pipe to adapter.
24.
Install purge and PCV hoses.
25.
Install throttle cable to bracket.
26.
Install throttle cable end to throttle body.
27.
Install air intake assembly and torque clamps to 15 Nm (11 lb. ft.).
28.
Connect Negative battery cable. Start and run engine one minute to verify engine operation (no Malfunction Indicator Lamp illumination).
29.
Reset all electrical devices as noted in step 1.
30.
Install the GM Campaign Identification Label.
Campaign Identification Label/Claim Information
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located 0 lator core support in an area which will be visible when the vehicle is brought in by the customer
for periodic servicing. When installing the Campaign Identification Label, be sure to install the clear protective covering. Additional Campaign
Identification.
Labels can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m. to 4:30 p.m. EST). Ask for Item Number
S-1015 when ordering.
