chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Swing Out Door|Page 10632 > < Recall - Rear Cargo Door Latch Replacement|Page 10629
Page 1
background image

Rear Door Latch: Service and Repair
Swing Out Door

Remove or Disconnect

1. Door trim panel.
2. Upper and lower door latch rods from the control assembly.

^

Using a flat bladed screwdriver push on the top of the clip where it is connected to the rod. Pivot the clip away from the rod.

3. Electric door actuator (if equipped).
4. Lock knob (356).
5. Rear door inside handle screw (364) and handle (365).
6. Rear door lock rod clip at the door panel.

^

Pivot the clip away from the rod.

7. Door to control assembly bolts (363).
8. Control assembly with lock rod through the access hole.

Install or Connect

Swing Out Door|Page 10632 > < Recall - Rear Cargo Door Latch Replacement|Page 10629