G 30 Van V8-454 7.4L VIN N TBI (1995)
Turn Signal Switch: Service and Repair
Fig. 1 Lock plate retaining ring removal
1.
Disconnect battery ground cable, then remove steering wheel. Refer to, Steering and Suspension/Steering/Steering Wheel/Service and Repair.
WARNING: Refer to Air Bags and Seat Belts/ Air Bags (Supplemental Restraint Systems)/ Service and Repair/ Air Bag System
Disarming & Arming.
2.
Remove shaft lock cover. Using lock plate compressor No. J-23653-C or equivalent, Fig. 1, compress lock plate and remove retaining ring.
3.
On standard columns, remove shaft lock, turn signal cancelling cam assembly, upper bearing spring and thrust washer.
4.
On tilt columns, remove shaft lock, turn signal cancelling cam assembly, upper bearing spring, upper bearing inner race seat and inner race.
5.
Position turn signal to Right turn position, then remove multi function lever.
6.
Remove signal switch arm attaching screw, then the switch.
7.
Remove hazard warning button assembly, then turn signal switch attaching screws.
8.
Disconnect turn signal switch electrical connector from wire harness.
9.
Remove socket and bracket assemble connector terminal from slot D of turn signal switch connector.
10.
Remove wiring protector.
11.
Remove turn signal switch, pulling wire harness through column.
12.
Reverse procedure to install.
