G 30 Van V8-454 7.4L VIN N TBI (1995)
Attaching Drive Lever Spring
REMOVE OR DISCONNECT
1. Governor throttle drive assembly.
-
Using your thumb, block the throttle cam lever at the 11 o'clock position, as shown.
2. Governor drive motor attaching screws.
3. Governor drive motor.
-
Slowly release the throttle cam lever spring tension.
INSTALL OR CONNECT
1. Spring to governor drive lever using a spring hook.
NOTE: The motor drive lever and spring must be aligned, as shown, to ensure correct drive motor installation.
2. Align the drive lever and spring.
-
Rotate the throttle cam lever clockwise until the cable barrel connection is at the 11 o'clock position and block with thumb, as shown.
3. Drive motor to the motor plate by aligning the mounting holes.
-
Tilt the motor slightly to allow the motor drive lever to clear the casting.
4. Four governor motor attaching screws coated with appropriate thread-locking compound.
Tighten
Attaching screws to 3 Nm (28 lb. in.).
5. Governor drive lever spring by rehooking using a spring hood.
Inspect
For correct attachment of the motor drive lever spring. Spring tension should increase as the motor drive lever is rotated clockwise. When
released, the motor drive lever should return to its park position (against the shock absorber), as shown.
6. Governor throttle drive assembly.
