HHR L4-2.0L Turbo (2010)
3. Install the inboard brake pad (1).
Note the location of the brake pad wear sensor.
4. Install the outboard brake pad (2).
5. Remove the support and pivot the brake caliper to the installed position.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the lower brake caliper guide pin bolt (1) and tighten to 35 Nm (26 lb ft).
7. Remove the wheel nuts retaining the brake rotor to the hub.
8. Install the tire and wheel assembly. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds then repeat steps 10-11 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and the brake pads.
13. Fill the master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master
Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling).
14. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing).
