HHR L4-2.0L Turbo (2010)
2. Install the oil filter cap and filter.
Caution: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.
Note: DO NOT use an open end wrench on the hex on top of the oil filter cap.
3. Use a J 44887 on the hex on the top of the oil filter cap.
Tighten the oil filter cap until fully seated. DO NOT exceed 25 Nm (18 lb ft).
4. Lower the vehicle.
5. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations (USA and Canada) (See: Fluids/Engine Oil/Specifications/Fluid Type
Specifications) and Approximate Fluid Capacities (See: Fluids/Engine Oil/Specifications/Capacity Specifications).
