HHR L4-2.0L Turbo (2010)
Note: A fuel injector may remain stuck in the cylinder head. If this occurs, complete the following steps:
1. Remove the fuel injector hold-down clamp before removing the fuel injector.
Note: Use the injector remover and slide hammer to pull the fuel injector straight out along the fuel injector axis. DO NOT tilt or twist the
fuel injector during this process.
2. Use J-37281-A - injector remover , and J-2619-01 - hammer to remove the fuel injector.
3. Once injectors have been removed it will be necessary to clean and rebuild all the injectors. Refer to Fuel Rail and Injectors Cleaning and
Inspection (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul).
Installation Procedure
1. Install the 2 outer fuel rail bolts (1) first, hand tight and install the remaining 2 bolts, hand tight.
2. Connect the fuel injector wiring harness electrical connectors to the fuel injectors.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).