HHR L4-2.0L Turbo (2010)
8. Connect the engine wiring harness electrical connector (1) to the fuel injector wiring harness electrical connector.
9. Inspect for leaks using the following procedure:
1. Turn ON the ignition, with the engine OFF for 2 seconds.
2. Turn OFF the ignition, for 10 seconds.
3. Turn ON the ignition, with the engine OFF.
4. Inspect for fuel leaks.
10. Install the low side fuel pressure service port cap.
11. Tighten the fuel fill cap.
12. Install the intake manifold assembly. Refer to Intake Manifold Replacement (See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service
and Repair).
