HHR L4-2.0L Turbo (2010)
Seals and Gaskets: Service and Repair
Front Wheel Drive Shaft Seal and Output Shaft Sleeve Replacement - Right Side
Front Wheel Drive Shaft Seal and Output Shaft Sleeve Replacement - Right Side
Special Tools
*
J 6125-1B Slide Hammer
*
J 8092 Driver Handle
*
J 23129 Universal Seal Remover
*
J 38868 Shaft Removal Tool
*
J 41102-1A Axle Seal Installer
*
J 41227 Output Shaft Sleeve Remover
*
J 41228 Output Shaft Sleeve Installer
Removal Procedure
Note:
*
The stub axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal separately.
*
Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the right drive axle assembly. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair).
3. Remove the snap ring from the stub axle shaft. Discard the snap ring. Do not reuse.
4. Install the J 38868 and J 6125-1B into the stub shaft snap ring groove.
5. Pull lightly on the shaft while rotating the shaft until the stub shaft snap ring at the differential seats in the taper on the differential side gear.