HHR L4-2.2L (2007)
12. Use the J 24319-B to separate the outer tie rods from the steering knuckles.
13. Remove the intermediate steering shaft to steering gear pinch bolt and discard.
Important: DO NOT rotate the intermediate shaft once separated from the gear. Possible damage or a malfunction could occur.
14. Disconnect the intermediate steering shaft from the steering gear.
15. Remove both lower control arm ball stud to steering knuckle pinch bolts.
Notice: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.
16. Lower the lower control arms in order to disengage the steering knuckle. If necessary, use the J 43631.
17. Mark the frame to body position with a paint pen or permanent marker.
