HHR L4-2.2L (2007)
3. Drill a 6.35 mm (1/4 in) diameter hole through the J-channel and fabric on each side. Ensure that the hole is centered in the J-channel as shown
above.
Tip
Once installed and trimmed, the tie strap length is much shorter than the starting 355 mm (14 in) length. A shorter tie strap can be used, however
the longer tie strap may be easier to get in position while working under the seat.
4. Insert a tie strap, obtained locally, into each hole in the toe kick panel. Approximate size of the tie strap should be 4.75 mm (0.187 in) width and
355 mm (14 in) length.
5. Reposition the toe kick panel and secure the two tie straps to the underside of the seat cushion.
Important
The seat cushion above has been removed for illustration purposes.
1. Slide each tie strap under the suspension wire of the seat cushion as shown above. Tighten the tie straps, ensuring that the toe kick panel fabric
is straight and taut.
2. Clip off the excess strap with wire snips.
Warranty Information
For vehicles repaired under warranty, use the table above.