HHR L4-2.2L (2007)
13. Direct water onto the module plate as seen in the illustration above.
14. Inspect the module plate for leaks at the guide pin or the plate to the sheet metal.
15. Direct the water behind the engine insulator pad on the right side of the engine compartment, directly above the rear window washer hose. Water
may be entering in this area.
16. Direct water under the cowl screen. Remove the cabin air filter and inspect for water coming in.
Condition 1
Carpet wet in the front or the rear.
Cause 1
The water deflector adhesive may not be sealed to the door and the drain hole may be covered over with adhesive.
Correction 1
Use two plastic trim sticks and install the sticks between the belt molding and the glass as seen in the illustration above. With the door open, apply water
to the glass. Water should only come out of the drains. If water is seen coming from behind the door trim, replace the water deflector. Refer to Front Or
Rear Side Door Water Deflector Replacement in SI.
Condition 2
Carpet wet in the front.
Cause 2
Water may be entering the mirror.
Correction 2
