HHR L4-2.2L (2007)
2. Remove the left and right wiper arms. Refer to SI if necessary.
3. Remove the four 7 mm screws and the two push-in retainers from each side of the grille panel.
4. Remove the five wire harness retainers from the grille panel.
5. Lift the panel up and place it on the engine.
6. Remove the butyl patch and clean the area with a 3M(TM) General Purpose Cleaner, or equivalent.
7. Apply a 6 mm (1/4 in) bead of windshield urethane, such as *Kent Industries Speed Set Windshield Sealant # P10545 or the equivalent, to the
perimeter of the opening on the cowl before installing the new sealing patch.
8. Install the sealing patch to the cowl opening and apply pressure to the outer edge of the patch.
9. Install the air inlet grille panel and tuck the weatherstrip into the side weatherstrip that runs down the fenders.
10. Install the four 7 mm screws and the two push-in retainers to each side of the grille panel.
Tighten
Tighten the four 7 mm bolts to 10 Nm (89 lb in).
11. Install the left and right wiper arms. Refer to SI if necessary.
12. Close the hood.
Parts Information
Purchase High-Tech seam sealer P10075 from Kent-Automotive.
Purchase Kent Industries Speed Set Windshield Sealant # P10545 from Kent-Automotive.
-
1-888-YES-KENT - Technical Service
-
1-800-654-6333 - Customer Service
-
www.kent-automotive.com
Warranty Information
