HHR L4-2.2L (2007)
1. Remove the caps or plugs from the opening in the brake caliper and the brake hose.
Important: Install NEW copper brake hose gaskets (2).
2. Assemble the NEW copper brake hose gaskets (2), and the brake hose bolt (1), to the brake hose (3).
Notice: Refer to Fastener Notice.
3. Install the brake hose-to-brake caliper bolt to the brake caliper.
Tighten the bolt to 44 N.m (33 lb ft).
4. Install the front brake hose bracket retaining bolt (3).
Tighten the bolt to 25 N.m (18 lb ft).
5. Remove the caps or plugs from the brake pipe fitting end and the brake hose end.
6. Using a backup wrench on the hose fitting (1), connect the brake pipe fitting (2) at the front brake hose.
Tighten the fitting to 21 N.m (15 lb ft).
7. Install the tire and wheel assembly.
8. Ensure that the hose does not make contact with any part of the suspension. Check the hose in extreme right and extreme left turn conditions. If the
hose makes contact, remove the hose and correct the condition.
9. Bleed the hydraulic brake system.
10. Lower the vehicle.