HHR L4-2.2L (2007)
1. Place the engine mount onto the side rail studs.
Notice: Refer to Fastener Notice.
2. Install the engine mount to side rail nuts.
Tighten the nuts to 100 N.m (74 lb ft).
Important: The engine mount to bracket bolts must be hand started. Do not pry the engine mount to align the holes.
3. Install the engine mount to bracket bolts.
4. Tighten the engine mount to bracket bolts.
Tighten the bolts to 50 N.m (37 lb ft).
5. Remove the hydraulic floor jack from under the oil pan.