HHR L4-2.2L (2007)
31. Use a suitable tool with a rubber tip on the end. Feed the tool down through the camshaft drive chain to rest on the timing chain. Then give a sharp
jolt diagonally downwards to release the tensioner.
32. Use a 24 mm wrench to hold the camshaft.
Tighten the NEW camshaft bolts to 85 N.m (63 lb ft) plus 30 degrees.
33. Install the camshaft cover.
34. Raise the vehicle. Refer to Vehicle Lifting.
35. Install the engine front cover.
36. Lower the vehicle.
37. Connect negative battery cable.
