HHR L4-2.2L (2007)
2. If the strut has not been modified previously, perform the following steps before continuing with the wheel alignment:
1. Disconnect the strut from the knuckle. Refer to Strut Assembly Replacement.
2. File the lower hole until the groove of the stamped ring around the hole.
3. Connect the strut to the knuckle. Refer to Strut Assembly Replacement.
3. Adjust the camber to specification by moving the top of the wheel in or out. Refer to Wheel Alignment Specifications.
Front Toe Adjustment
1. Ensure that the steering wheel is set in a straight ahead position.
2. Loosen the tie rod jam nut (5).
3. Adjust the toe to specification by turning the inner tie rod (6). Refer to Wheel Alignment Specifications.
Notice: Refer to Fastener Notice.
4. Tighten the tie rod jam nut (5).
Tighten the tie rod jam nut (5) to 68 N.m (50 lb ft).
