HHR L4-2.2L (2007)
9. Disconnect the fuel feed pipe quick connect fitting.
10. Remove the brake lines from the fuel/EVAP/brake line brackets.
11. Remove the fuel/EVAP/brake line bracket nuts and remove the brackets from the body studs.
12. Remove the fuel and EVAP lines from the vehicle.
13. Open the brackets and remove the EVAP pipe.
Installation Procedure
1. Install the EVAP pipe to the brackets and close the covers.
2. Install the fuel and EVAP lines to the vehicle.
3. Install the fuel/EVAP/brake line bracket to the body studs.
Notice: Refer to Fastener Notice.
4. Install the fuel/EVAP/brake line bracket nuts.
