HHR L4-2.2L (2007)
4. Insert terminal into the appropriate terminal holder until it hits bottom and stops. The correct terminal holder is determined by the wire size. Also
ensure that the terminals wings are pointing towards the former on the tool and the release locator.
5. Insert the stripped cable into the terminal. Insulation should be visible on both sides of the terminal insulation wings.
6. Compress the handles until the ratchet automatically releases.
7. Place the terminal into the appropriate cavity and assemble the connector.
Micro-Pack 100W Connectors
MICRO-PACK 100W CONNECTORS
TERMINAL REMOVAL PROCEDURE
1. Disconnect the connector from the component or separate the connector halves for in-line connectors.
2. Locate the nose piece locking tabs that are positioned on the side of the connector nose piece.