HHR L4-2.2L (2007)
vehicles listing" before ordering parts. Normal orders should be placed on a DRO = Daily Replenishment Order. In an emergency situation, parts should
be ordered on a CSO = Customer Special Order.
Service Procedure
Tools Required
Hot Glue Gun
Important:
Install the energy absorbing (EA) plastic piece into the headliner at both the driver and passenger side A-pillar locations.
1.
Remove the A-pillar trim panels. Refer to Windshield Garnish Molding Replacement in SI.
2.
Remove the sunshades from the vehicle. Refer to Sunshade Replacement in SI.
3.
Remove the door weatherstrip (1).
Important:
The headliner will drop about 203 mm (8 in), which will provide adequate room to install the insert energy absorbing (EA) plastic piece (2)
into the headliner (3). Use GM Care Hot Melt Adhesive Sticks (P/N 12377914) or equivalent to glue the EA plastic piece (2) into the headliner
(3).
4.
Locate the installation point for installing the energy absorbing (EA) plastic piece (2) onto the A-pillar edge (1) of the headliner (3).