HHR L4-2.2L (2007)
Ignition Lock Solenoid: Service and Repair
IGNITION LOCK CYLINDER SOLENOID REPLACEMENT
REMOVAL PROCEDURE
1. Remove the steering column trim covers.
2. Disconnect the ignition lock cylinder solenoid harness connector.
3. Remove the ignition lock cylinder solenoid screws.
4. IMPORTANT: Do not attempt to remove any roll pins retaining the plunger mechanism. The ignition lock cylinder solenoid replacement part
consists of only the solenoid and spring. If the plunger mechanism exhibits any signs of damage or wear then replacement of the ignition lock
cylinder case will be necessary.
Remove the ignition lock cylinder solenoid from the lock cylinder case housing.
