HHR L4-2.2L (2007)
4. While lightly holding the pedal, install and adjust the clutch pedal position switch:
1. If a new clutch pedal assembly is being installed, the pedal assembly will include a clutch pedal position switch adjustment spacer in place
over the switch contact rubber bumper.
2. If the pedal assembly is being reused, position a 2 mm (5/64 in) drill bit or hex wrench as a spacer over the face of the switch contact rubber
bumper.
3. Insert the clutch pedal position switch into the retainer.
4. Ensure the switch plunger is fully depressed against the adjustment spacer, drill bit, or hex wrench without deflecting the bracket or the switch
contact arm on the pedal.
5. Rotate the switch clockwise to secure the switch in the retainer.
6. Remove the adjustment spacer, drill bit, or hex wrench.
5. Release the clutch pedal and inspect the switch barrel to switch contact rubber bumper clearance (1).
Clearance should not exceed 1.2 mm (0.047 in).
6. Install the sound insulator.