HHR L4-2.2L (2007)
4. Adjust the clutch pedal engine start switch:
1. If a new clutch pedal assembly is being installed, the pedal will include a clutch pedal engine start switch adjustment spacer in place over the
switch contact rubber bumper.
2. If the pedal assembly is being reused, position a 4 mm (5/32 in) drill bit or hex wrench as a spacer over the face of the switch contact rubber
bumper.
3. With the adjustment spacer, drill bit, or hex wrench in place, depress the clutch pedal to full travel. As the pedal reached full travel an audible
noise will be heard as the switch ratchets back in the retainer to position.
4. Remove the adjustment spacer, drill bit, or hex wrench.
5. Inspect for proper operation of the clutch pedal engine start switch.
6. Install the sound insulator.
