HHR L4-2.2L (2007)
13. Separate the grommet (1) from the floor pan.
14. Remove the cable from the vehicle by pulling the cables through the drivers floor opening.
Installation Procedure
1. Feed the cable assembly through the drivers floor opening.
2. Install the grommet (1) flush with the floor opening.
3. Install the drivers side front carpet.
4. Install the left instrument panel closeout panel.
5. Raise the vehicle.
Notice: Refer to Fastener Notice.
6. Install the shift cable attachment nut to the underbody.
Tighten the nut to 10 N.m (89 lb in).
7. Lower the vehicle.
8. Install the shift cables to the transmission cable bracket.
