HHR L4-2.4L (2010)
Acceleration/Deceleration Sensor: Service and Repair
Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement
Removal Procedure
1. Turn OFF the ignition.
2. Remove the right front seat. Refer to Front Seat Replacement - Bucket (See: Body and Frame/Seats/Service and Repair/Front Seat Replacement -
Bucket).
3. Remove the right side body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side (See: Body and
Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Body Hinge Pillar Trim Panel Replacement - Right Side).
4. Carefully lift the floor carpet to access the yaw rate sensor.
To ease access to the yaw rate sensor, it may be necessary to carefully cut a small section of the floor carpeting neat the yaw rate sensor.
5. Disconnect the yaw rate sensor electrical connector.
6. Remove the yaw rate sensor nuts (1).