HHR L4-2.4L (2010)
6. Remove the inboard brake pad (1).
Note the location of the brake pad wear sensor.
7. Remove the outboard brake pad (2).
8. Remove the disc brake pad retainers (6) from the brake caliper bracket.
9. Thoroughly clean the brake pad hardware mating surfaces of the caliper bracket (3) of any debris and corrosion.
10. Inspect the disc brake pad retainers (6) for the following:
*
Bent mounting tabs
*
Excessive corrosion
*
Looseness at the brake caliper mounting bracket
*
Looseness at the disc brake pads
11. If any of the conditions listed are found, the disc brake pad retainers require replacement.
12. Remove the brake caliper guide pins (1, 4) from the brake caliper bracket.
13. Remove the caliper guide pin boots (5) from the caliper bracket.
Replace the caliper guide pin boots if damaged.
