HHR L4-2.4L (2010)
1. Install the brake caliper mounting bracket to the rear axle.
Caution: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a
standard tap. If a standard tap is used, damage to the joint threads will occur.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the brake caliper bracket bolts (1).
Tighten the bolts to 115 Nm (85 lb ft).
3. Apply a very thin coating of high temperature silicone brake lubricant to the pad hardware mating surfaces of the caliper bracket (2) only.
4. Clean the brake pad mating surfaces of the brake pad retainers (1).
5. Install the brake pad retainers (1) to the brake caliper bracket.
Note: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake rotor
during forward wheel rotation, or at the bottom of the pad when installed in vehicle position.
