HHR L4-2.4L (2010)
Note: Ensure that the brake pipe end to be flared is cut at a square, 90 degree angle to the pipe length.
6. Using the pipe cutter included in the J-45405 - Pipe Flaring Tool Kit , carefully cut the brake pipe squarely to the measured length.
7. Remove the sectioned brake pipe from the vehicle.
8. Select the appropriate size of brake pipe and tube nuts, as necessary. The brake pipe outside diameter determines brake pipe size.
9. Strip the nylon coating from the brake pipe end to be flared, if necessary.
1. Select the appropriate blade on the coating stripping tool included in the J-45405 - Pipe Flaring Tool Kit , by unthreading the blade block from
the stripping tool and installing the block with the desired blade facing the tool rollers.
*
6.35 mm (0.250 in) blade for 4.76 mm (3/16 in) diameter pipe
*
9.50 mm (0.374 in) blade for 6.35 mm (1/4 in) and 7.94 mm (5/16 in) diameter pipe
2. Insert the brake pipe end to be flared into the stripping tool to the depth of the ledge on the tool rollers.
3. While holding the brake pipe firmly against the stripping tool roller ledges, rotate the thumbwheel of the tool until the blade contacts the brake
pipe coated surface.
Note: Do not gouge the metal surface of the brake pipe.
4. Rotate the stripping tool in a clockwise direction, ensuring that the brake pipe end remains against the tool roller ledges.
5. After each successive revolution of the stripping tool, carefully rotate the thumbwheel of the tool clockwise, in order to continue stripping the
coating from the brake pipe until the metal pipe surface is exposed.
6. Loosen the thumbwheel of the tool and remove the brake pipe.
Note: Ensure that all loose remnants of the nylon coating have been removed from the brake pipe.
7. Inspect the stripped end of the brake pipe to ensure that the proper amount of coating has been removed.
*
6.35 mm (0.250 in) for 4.76 mm (3/16 in) diameter pipe
*
9.50 mm (0.374 in) for 6.35 mm (1/4 in) and 7.94 mm (5/16 in) diameter pipe
