HHR L4-2.4L (2010)
22. Looking at the front of the straight edge, inspect to see if light is protruding through the bottom of the straight edge and the top of the cylinder
block deck surface. If light is present on both sides of the cylinder block, the cylinder bore sleeve is cut correctly.
23. Proceed to the next bore sleeve to be trimmed, repeating steps 10-19 if necessary.
24. Install the piston and the connecting rod. Refer to Piston, Connecting Rod, and Bearing Replacement (2.4L) (See: Piston/Service and Repair
)Piston, Connecting Rod, and Bearing Replacement (2.2L) (See: Piston/Service and Repair).
