HHR L4-2.4L (2010)
8. Slowly raise the module until the fuel level sensor float arm is just visible. Ensure that the fuel level sensor harness connector clears the tank
opening.
Note: When removing the module from the fuel tank, be aware that the module reservoir bowl is full of fuel. The module must be tipped slightly
during removal to avoid bending the fuel level sensor float arm.
9. Tilt the module toward the rear of the fuel tank to allow the level sensor float arm to clear the tank opening. Remove the module from the tank.
10. Carefully discard the fuel in the module reservoir bowl into an approved fuel container.
Note: DO NOT reuse the old fuel pump module seal.
11. Remove and discard the fuel pump module seal.
Note:
*
Some lock ring were manufactured with DO NOT REUSE stamped into them. These lock rings may be reused if they are not damaged or
warped.
*
Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock ring.
