HHR L4-2.4L (2010)
6. Inspect the seal for damage.
Installation Procedure
1. Install the NEW MAP sensor seal, if required.
2. Install the MAP sensor.
3. Connect the MAP sensor electrical connector.
4. Position the wiring harness and connect the harness clips to the fuel rail.
5. Connect the EVAP purge tube to the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Delivery and Air
Induction/Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
6. Install the throttle body. Refer to Throttle Body Assembly Replacement (See: Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal and Replacement).
