HHR L4-2.4L (2010)
6. If equipped with a automatic transaxle, perform the following steps, connect the engine harness electrical connector (3) to the HO2S.
7. Install the CPA retainer (2).
8. If equipped with a manual transaxle, install the wheel drive shaft heat shield. Refer to Front Wheel Drive Shaft Joint Boot Shield Replacement (
See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Constant Velocity Joint Boot/Service and Repair/Front
Wheel Drive Shaft Joint Boot Shield Replacement).
