HHR L4-2.4L (2010)
9. Using a small flat-bladed tool, carefully pry the 2 retaining tabs away at the base of the SIR coil assembly and slide the SIR coil assembly off of
the steering column.
10. Remove the headlamp/turn signal switch from the SIR coil module assembly. Refer to Turn Signal Multifunction Switch Replacement (See:
Lighting and Horns/Sensors and Switches - Lighting and Horns/Turn Signal Switch/Service and Repair).
11. Remove the wiper washer switch from the SIR coil module assembly. Refer to Windshield Wiper and Washer Switch Replacement (See: Sensors
and Switches/Sensors and Switches - Wiper and Washer Systems/Windshield Washer Switch/Service and Repair/Windshield Wiper and Washer
Switch Replacement).
Installation Procedure
1. Install the wiper washer switch from the SIR coil module assembly. Refer to Windshield Wiper and Washer Switch Replacement (See: Sensors
and Switches/Sensors and Switches - Wiper and Washer Systems/Windshield Washer Switch/Service and Repair/Windshield Wiper and Washer
Switch Replacement).
2. Install the headlamp/turn signal switch to the SIR coil module assembly. Refer to Turn Signal Multifunction Switch Replacement (See: Lighting
and Horns/Sensors and Switches - Lighting and Horns/Turn Signal Switch/Service and Repair).
3. Install the headlamp/turn signal switch screws.
4. Verify the SIR coil is in the center position. Refer to Inflatable Restraint Steering Wheel Module Coil Centering (See: Procedures).
5. Slide the SIR coil assembly on the steering column and snap into place.
