HHR L4-2.4L (2010)
Note: Inspect the CMP sensor for damage, replace as necessary.
1. Lubricate the CMP sensor O-ring seal with clean engine oil.
2. Install the CMP sensor. Intake CMP shown, exhaust CMP similar.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the CMP sensor bolt.
Tighten the bolt to 10 Nm (89 lb in).
4. Connect the exhaust CMP sensor electrical connector (1).
5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine
Performance Checks/Air Cleaner Housing/Service and Repair).
