HHR L4-2.4L (2010)
only the solenoid and spring. If the plunger mechanism exhibits any signs of damage or wear then replacement of the ignition lock cylinder case
will be necessary.
4. Remove the ignition lock cylinder solenoid from the lock cylinder case housing.
Installation Procedure
Note: Clean the solenoid and plunger with a lint free cloth prior to installation. Oil or debris may cause ignition lock cylinder solenoid
malfunction.
1. Install a new spring over the ignition lock cylinder solenoid plunger.
2. Carefully install the new ignition lock cylinder solenoid over the plunger.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Seat the ignition lock cylinder solenoid on the lock cylinder case housing and install the screws.
Tighten the screws to 2 Nm (17 lb in).
