HHR L4-2.4L (2010)
visually choose the terminal test adapter because some connector terminal cavities may appear larger than the actual terminal in the cavity. Using a larger
terminal test adapter will damage the terminal. Refer to the EL-35616 GM-Approved Terminal Test Kit label on the inside of the EL-35616
GM-Approved Terminal Test Kit for the correct adapter along with the connector end view for terminal size.
Using Fused Jumper Wires
Using Fused Jumper Wires
Special Tools
J 36169-A Fused Jumper Wire
Note: A fused jumper may not protect solid state components from being damaged.
The J 36169-A includes small clamp connectors that provide adaptation to most connectors without damage. This fused jumper wire is supplied with a
20-A fuse which may not be suitable for some circuits. Do not use a fuse with a higher rating than the fuse that protects the circuit being tested.
AFL/EPC Connectors
AFL/EPC Connectors
Special Tools
J-38125 Terminal Repair Kit
Removal Procedure
Follow the steps below in order to remove terminals from the connector.
1. For connectors with a bolt in the dress cover, turn the bolt counterclockwise to remove the connector from the component.
