HHR L4-2.4L (2010)
2. Position the wheel bearing/hub assembly (3) in the trailing arm and brake backing plate (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the wheel bearing/hub mounting nuts (1).
Tighten the wheel bearing/hub mounting nuts to 45 Nm (33 lb ft). Using the J 45059 , rotate the mounting nuts an additional 30
degrees.
4. Install the rear brake drum, if equipped. Refer to Brake Drum Replacement (See: Brakes and Traction Control/Drum Brake System/Brake
Drum/Service and Repair/Removal and Replacement).
5. Install the rear brake rotor, if equipped. Refer to Rear Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
7. Remove the support and lower the vehicle.
