Impala V6-3.4L VIN E (2000)
1. Install the engine mount strut.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine wiring harness retainer, the bolt, and the nut to the engine runout strut at the engine mount strut bracket on the upper radiator
support.
Tighten the engine mount strut bolt to 48 Nm (35 ft. lbs.).
3. Install the bolt and the nut to the engine mount strut at the left engine mount strut bracket on the engine.
Tighten the engine mount strut nut to 48 Nm (35 ft. lbs.).
Engine Mount Strut Replacement (Right)
Removal Procedure
1. Remove the bolt and the nut from the engine mount strut at the right engine mount strut bracket on the engine.
