Impala V6-3.5L VIN N (2006)
Brake Pedal Assy: Service and Repair
Brake Pedal Assembly Replacement
Removal Procedure
1. Remove the left instrument panel insulator.
2. Push the BCM up and move the bottom of the BCM away from and out of the mounting bracket slot. Position the BCM aside.
3. Remove the cruise control release switch, if equipped.
4. Release the wiring harness clips from the bracket.
5. Remove the brake pedal pushrod retaining clip from the brake pedal.
6. Remove the brake pedal pushrod and washer from the brake pedal.
7. Remove the brake pedal nut and bolt.
8. Remove the brake pedal and bushings.
Installation Procedure
1. Install the brake pedal and bushings.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake pedal nut and bolt.
Tighten the brake pedal nut and bolt to 40 Nm (30 ft. lbs.).
