Impala V6-3.5L VIN N (2006)
9. Remove the radiator upper air baffle and deflector and locate the left and right front end sensor (1, 4).
10. Remove the connector position assurance (CPA) (3, 6) from both front end sensors connector (2, 5).
11. Remove both front end sensor connectors (2, 5) from each front end sensor (1, 4).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect both front end sensor connectors (2, 5) to each front end sensor (1, 4).
3. Install both CPA's (3, 6) into each front end sensor connector (2, 5).
4. Install the radiator upper air baffle and deflector.
5. Install both Air Bag Fuses, one in the underhood fuse center and one in the interior fuse center.
6. Replace both fuse center covers.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.Perform the
Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle.
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures
SIR Disabling and Enabling Zone 2
